Page 210 - Polycoat 1.1 Table of Contents

TECHNICAL DATA SHEET | Section 11.7
POLYGLAZE® HARDENER
Basecoat Thickener / Accelerator

Product Description
Polyglaze® Hardener is a single component, low viscosity, Technical Data (Based on Draw Down Film)
accelerating agent. This accelerator enhances the moisture
curing characteristics of all grades of Polyglaze® coatings Pot Life at 75°F (24°C), 50% R.H. 1-3 hours
and all grades of the Poly-I-Gard 246 coatings. Please select (during application)
™
the correct Product Grade which comply with VOC regulations
as per Federal, State, Statutory Bodies, County and City Volume Mixing Ratio, 1:20
Regulations/Codes at the place of installation of product. Polyglaze® Hardener:
Polyglaze®/ Poly-I-Gard ™
Features
• Fast Cure Time Specific Gravity 0.87

• Saves in Labor Cost – Apply Two Coats in One Day
Viscosity at 75°F (24°C) 100 ± 50 cps
Typical Uses
• Creates a Caulking Compound for Plywood Joints,
Cracks, Concrete Expansion Joints and Flashings
• Vertical Surfaces
• When Quick Access is Necessary
Polyglaze® Hardener has a shelf life of one (1) year from date
Packaging of manufacture in original, factory-sealed containers when
stored indoors at a temperature between 60-95°F (15-35°C).
1 quart (0.95 liter) can Limitations
Not recommended for indoor applications. Should be used in
well-ventilated areas due to its strong odor. Containers that
Color
have been opened must be used within 1-3 hours. Polyglaze®
Clear (Pale Yellow) Hardener may react with atmospheric moisture and render it
Mixing unusable. Do not dilute under any circumstance.
Polyglaze® Hardener may be mixed into all grades of Polyglaze® Not for use with Poly-I-Gard 295 or Poly-I-Gard 295OF.
™
™
™
and all grades of Poly-I-Gard 246 surface protection coatings Warning
by using a mechanical mixer. Mix Polyglaze® Hardener into This product contains Curatives.
the topcoat until a homogeneous mixture and color is attained. This product is considered Dangerous Goods. DOT regulations classify it
Do not mix in an up and down motion. as: UN 1760, CORROSIVE LIQUID N.O.S., (Contains Amine), Class 8, PG III.
VOLUME MIXING RATIO:
0.5 pint Polyglaze® Hardener to 1 gallon Polyglaze/Poly-I-
Gard™ 246 (0.24 liters Polyglaze® Hardener to 3.78 liters
Polyglaze®/Poly-I-Gard 246).
™
- OR -
1 Quart Polyglaze® Hardener to 5 gallons Polyglaze®/Poly-
I-Gard 246 (0.95 liters Polyglaze® Hardener to 18.9 liters
™
Polyglaze®/Poly-I-Gard 246).
™
The pot life of the resulting compound is approximately 1-3
hours at 75°F (24°C) and 50% relative humidity.
Cleanup
Equipment should be cleaned with an environmentally safe
solvent, as permitted under local regulations, immediately
after use.

Storage

POLYCOAT PRODUCTS TEL 562.802.8834 | FAX 562.921.7363 Section 11.7
wpsales@polycoatusa.com | www.polycoatusa.com