Page 214 - Catalogs

TECHNICAL DATA SHEET | Section 11.8
QUICK-N-CURE™
Liquid Catalyst

Product Description
Quick-N-Cure™ is a single component, proprietary, liquid Technical Data (Based on Draw Down Film)
catalyst that reduces the cold weather cure time of aromatic
polyurethane polyurea coatings. Quick-N-Cure™ may be used Pot Life at 75°F (24°C), 50% 4-6 hours
to speed the cure of Polyglaze™ AR, AR-SF, PC-220, PC-220SF, R.H.
PC-220OF, PC-440, PC-440SF, PC-440SC, Poly-I-Gard 246,
™
Poly-I-Gard 246SF, Poly-I-Gard 246OF, Poly-I-Gard 246SC. Minimum Mixing ratio 0.6 oz/1 gal
™
™
™
Quick-N-Cure™: Aromatic 10cc/3.37 liters
Features Coating
• Quick-N-Cure™ may be used to accelerate cure time in
cold weather applications Specific Gravity 1.008
Total Solids by Weight, ASTM 100%
Typical Uses D2369
• Creates a Caulking Compound for Plywood Joints,
Cracks, Concrete Expansion Joints and Flashings Total Solids by Volume, ASTM 100%
• Vertical Surfaces D2697
• When Quick Access is Necessary Viscosity at 75°F (24°C) 100 ± 50 cps

Packaging
Volatile Organic Compounds, 0 lb/gal
0.7 ounce (20 gram) vial ASTM D-2369-81 0 gm/liter

1 quart (0.95 liter) can

Color and amount of Quick-N-Cure™ used.
Red Storage
Mixing Quick-N-Cure™ has a shelf life of one (1) year from date of
Maximum mixing ratio: 0.2 to 0.6 ounces Quick-N-Cure™ to manufacture in original, factory-sealed containers when stored
1 gallon Aromatic Coating (5.9cc to 17.7cc Quick-N-Cure™ to indoors at a temperature between 60-95°F (15-35°C).
3.78 liters Aromatic Coating). Limitations
For use in cold temperatures only. Excessive Quick-N-Cure™
- OR -
will result in a reduction of the physical properties of the base
1 to 3 ounces Quick-N-Cure™ to 5 gallons Aromatic Coating membrane.
(29.6cc to 88.7cc Quick-N-Cure™ to 18.9 liters Aromatic
Coating). Adding excessive amounts of Quick-N-Cure™ may result in
foaming. Containers that have been opened must be used
The amount of catalyst to be added should be determined as soon as possible. Do not dilute under any circumstance.
based on job conditions. However, it is recommended that Warning
not more than 0.1% to 0.2% of Quick-N-Cure™ be added (by This product contains Curatives.
weight) to the coating.
Mix Quick-N-Cure™ into the coating by using a mechanical
mixer. Mix Quick-N-Cure™ into the coating until a homogeneous
mixture and color is attained. Do not mix in an up and down
motion.
The pot life of the resulting compound will be approximately
4-6 hours. This time will vary based on temperature, humidity

POLYCOAT PRODUCTS TEL 562.802.8834 | FAX 562.921.7363 Section 11.8
wpsales@polycoatusa.com | www.polycoatusa.com