Page 212 - Catalogs

TECHNICAL DATA SHEET | Section 11.7
POLYGLAZE® HARDENER
Basecoat Thickener / Accelerator

Product Description
Polyglaze® Hardener is a single component, low viscosity, Technical Data (Based on Draw Down Film)
accelerating agent. This accelerator enhances the moisture
curing characteristics of all grades of Polyglaze® coatings Pot Life at 75°F (24°C), 50% 1-3 hours
and all grades of the Poly-I-Gard 246 coatings. Please select R.H.
™
the correct Product Grade which comply with VOC regulations (during application)
as per Federal, State, Statutory Bodies, County and City
Regulations/Codes at the place of installation of product. Volume Mixing Ratio, 1:20
Polyglaze® Hardener:
Features Polyglaze®/ Poly-I-Gard ™
• Fast Cure Time
Specific Gravity 0.87
• Saves in Labor Cost – Apply Two Coats in One Day
Typical Uses Viscosity at 75°F (24°C) 100 ± 50 cps
• Creates a Caulking Compound for Plywood Joints,
Cracks, Concrete Expansion Joints and Flashings
• Vertical Surfaces
• When Quick Access is Necessary
Storage
Packaging Polyglaze® Hardener has a shelf life of one (1) year from date
of manufacture in original, factory-sealed containers when
1 quart (0.95 liter) can stored indoors at a temperature between 60-95°F (15-35°C).
Limitations
Color Not recommended for indoor applications. Should be used in
well-ventilated areas due to its strong odor. Containers that
Clear (Pale Yellow) have been opened must be used within 1-3 hours. Polyglaze®
Mixing Hardener may react with atmospheric moisture and render it
Polyglaze® Hardener may be mixed into all grades of Polyglaze® unusable. Do not dilute under any circumstance.
™
and all grades of Poly-I-Gard 246 surface protection coatings Not for use with Poly-I-Gard 295 or Poly-I-Gard 295OF.
™
™
by using a mechanical mixer. Mix Polyglaze® Hardener into Warning
the topcoat until a homogeneous mixture and color is attained. This product contains Curatives.
Do not mix in an up and down motion. This product is considered Dangerous Goods. DOT regulations classify it
VOLUME MIXING RATIO: as: UN 1760, CORROSIVE LIQUID N.O.S., (Contains Amine), Class 8, PG III.
0.5 pint Polyglaze® Hardener to 1 gallon Polyglaze/Poly-I-
Gard™ 246 (0.24 liters Polyglaze® Hardener to 3.78 liters
Polyglaze®/Poly-I-Gard 246).
™
- OR -
1 Quart Polyglaze® Hardener to 5 gallons Polyglaze®/Poly-
I-Gard 246 (0.95 liters Polyglaze® Hardener to 18.9 liters
™
Polyglaze®/Poly-I-Gard 246).
™
The pot life of the resulting compound is approximately 1-3
hours at 75°F (24°C) and 50% relative humidity.
Cleanup
Equipment should be cleaned with an environmentally safe
solvent, as permitted under local regulations, immediately
after use.

POLYCOAT PRODUCTS TEL 562.802.8834 | FAX 562.921.7363 Section 11.7
wpsales@polycoatusa.com | www.polycoatusa.com