Polycoat Warranty Application

This form is to be submitted to Polycoat Products upon completion of the project. For a Polycoat Products Warranty, all materials used must be manufactured by Polycoat Products.

 

A warranty fee of $150.00 will be charged to the applicator for projects less than 10,000 square feet.

Break the above square footage into the following:(Feet2)

Light to medium traffic: Feet2 (Foot traffic, parking stalls, etc.)
Heavy traffic: Feet2 (Normal vehicular traffic, etc.)
High volume traffic: Feet2 (Turn areas, etc.)

Substrate:

If the substrate is concrete, what was the surface preparation?

Were all cracks and expansion joints detailed per Polycoat Products General Guidelines and Technical Data Sheets?

Which primer was used?

If the substrate is plywood, please answer the following:

Is the plywood APA stamped?

What is the plywood thickness?

Was the plywood installed according to Polycoat Products General Guidelines?

Is the plywood free of grain checking, oils, old coatings or other contamination?

Are all the plywood joints properly sealed according to Polycoat Products general Guidelines and published Technical Data?

Were all plywood seams reinforced with Polycoat Products Straight Jacket or Polyester Tape and detailed according to Polycoat Products General Guidelines and Technical Data Sheets.

What type of slip resistant material was used:

Pounds per square foot:

Was the Polycoat Products Coating System applied over existing coating?

Prior to coating the surface was a successful adhesion test completed over the existing coating to assure the Polycoat Products Coating System was compatible with the existing coating?

If yes, give data that test was complete and type of test performed:

Is the pre-existing coating well adhered to the substrate?

Was the pre-existing coating cleaned prior to application?

Was substrate clean, dry and free of any loose coating prior to re-coating?

What primer was used:

At what rate was it applied:

Was the primer used allowed to become tack free prior to coating?

Were all angles treated according to Polycoat Products General Guidelines and Technical Data Sheets prior to coating the surface?

Was the Polycoat Products Coating System terminated in a manner that eliminates the possibility of water from another area that is not being waterproofed to migrate into the area being waterproofed?

What type of slip resistant material was used:

Pounds per square foot:

Was a grid system used to assure the proper amount of coating was being applied?

Does the Polycoat Products Coating System terminate with natural termination(s) such as walls, expansion joints, control joints or keyways?

Describe in detail the locations and areas that the warranty is being requested for:

The following is to be completed by an officer of the contractor applying for the Polycoat Products Warranty:

Copies of Invoices Included:

Warranty Form (Download)