Page 51 - Catalogs
P. 51
GUIDE SPECIFICIATIONS | Section 2.9
POLYDECK 400
®
to 254 ± 51 microns) thick membrane. At 75°F (24°C) and exact coverage rates necessary to waterproof the deck to
50% relative humidity, allow 72 hours of cure time before acceptable standards.
permitting heavy traffic on the finished system.
Equipment should be cleaned with a urethane grade
FINISHED SYSTEM: environmentally safe solvent, as permitted under local
When applied as directed, the Polydeck 400 Pedestrian regulations, immediately after use. Uncured materials
®
Traffic Deck System will provide 70 to 94 ± 5 dry mils (1778 to are sensitive to heat and moisture. The substrate must be
2388 ± 125 dry microns), exclusive of aggregate, of superior structurally sound and sloped for proper drainage. Polycoat
waterproofing protection. Requires a continuous coating Products assumes no liability for substrate defects. Field visits
application to minimize lines and/or streaking. Any optional by Polycoat Products personnel are for the purpose of making
adhesion test is to be performed seven days after product technical recommendations only and are not to supervise or
application. provide quality control on the job site.
Limitations
The following conditions must not be coated with Polycoat Warning
Products deck coating systems or products: on grade slabs, The products in this system contain Isocyanates, Solvents, Epoxy Resin,
split slabs with buried membrane, sandwich slabs with and Curatives.
insulation, slabs over unvented metal pan, magnesite, or
concrete with a structural integrity less than 3000 psi. Asphalt
surfaces and asphalt overlays may be coated with Polycoat
decking systems if first coated with the Polycoat™ PC-IM 129.
Concrete must exhibit 3000 psi minimum strength. Concrete
surfaces to be coated must be trowel finished in compliance with
the American Concrete Institute (except that hand troweling
is not required), followed by a fine-haired brooming, left free
of loose particles, and shall be without ridges, projections,
voids and concrete droppings that would be mechanically
detrimental to coating application or function.
New concrete must be cured for 28 days (see General
Guidelines). Polycoat Products coating systems should not
be subjected to rising water tables or hydrostatic pressure on
slab-on-grade decks. The only acceptable grade of plywood
is APA rated exterior grade or better. The appearance and
physical characteristics of the plywood and grade should be
considered. Plywood should be new or cleaned and sanded
(see General Guidelines). The coating should be applied at
least 5°F (3°C) above the dew point.
Coverage rates recommended are based on lab conditions,
applied at 75°F (24°C) ambient temperature and are intended
to be minimum coverage rates on clean, smooth plywood, and
are exclusive of additional amounts needed to fill potholes,
spalling, scaling, rough and irregular surfaces. Porosity and
roughness of the substrate, aggregate size, and product
temperature will affect coverage rates. Material mil thickness
rates are calculated on theoretical coverage for a smooth
substrate and do not account for the actual texture or substrate
conditions in the field or at the time of application. Sample
mockups on the projects are recommended to determine the
POLYCOAT PRODUCTS TEL 562.802.8834 | FAX 562.921.7363 Section 2.9
wpsales@polycoatusa.com | www.polycoatusa.com